Oven & Range Repair in Seattle and Surrounding Cities
Cold oven, uneven baking, or a burner that will not light: describe the problem and request a connection to an independent repair provider.
Same-day requests are welcome, but provider availability must be confirmed. No appointment or response time is guaranteed. We are a referral service and do not perform repairs.
- Independent providers, not our employees
- You approve the price before work starts
- No payment to submit a request
- Refrigerator, washer, dryer, oven, dishwasher
A cold oven the night before guests arrive is the kind of problem that reminds you how much you rely on your kitchen. This page covers the faults that come up most often with gas and electric ovens, ranges, and cooktops in the Seattle area, what is safe to check yourself, and what repairs tend to cost.
Sound Appliance Connect is a referral service, not a repair company. We do not employ technicians. With your permission, we forward your request to an independent provider who covers your area, if one is available. The provider discusses the visit, the diagnostic fee, and the repair price with you directly, and you decide whether to proceed.
Common oven & range problems
The oven will not heat
In an electric oven, a burnt-out bake element is the most common cause. You can often see a blister or a break in the coil. In a gas oven, a weak igniter that glows but does not open the gas valve is a very common fault. A control board, temperature sensor, or relay can also stop heating. An oven that works for broil but not bake points toward the bake element or the control.
Uneven baking or the wrong temperature
If the oven is much hotter or cooler than the dial, the temperature sensor may be drifting, or the control calibration may be off. An oven thermometer in the center of the rack will tell you how far off it is. Uneven browning can come from a worn door gasket, a failing convection fan, or an element that is only partly working.
A cooktop burner that will not light or heat
On a gas cooktop, clogged burner ports, a wet or dirty igniter, or a failed spark module can stop burners from lighting. On an electric coil, a burnt element or a bad receptacle is typical. On a smooth-top, a failed infinite switch or a broken element can leave a zone dead. Induction cooktops have their own diagnostics, and may need specialized service.
Self-clean cycle problems
Self-clean cycles run at very high heat, which stresses door locks and control boards. A door that locks and will not open, or a cycle that trips error codes, can be a failed latch motor or a failed thermal fuse. Avoid starting a cycle if the oven is already acting unreliably.
Door will not close, latch, or seal
A door that hangs open or has a gap lets heat escape and makes cooking uneven. Worn hinges, a broken spring, or a damaged gasket are typical causes. A gasket can be replaced without much trouble on many models.
A gas smell near the range
Stop. Do not light anything or touch switches. Leave the home, then call Puget Sound Energy or 911 from outside. A faint odor right after you light the oven is not unusual, but a persistent smell is not safe.
Clock, display, or touchpad failures
A dead display or non-responding keypad often points to a control board or a ribbon cable. Power surges after storms and moisture near the stove can damage electronics.
Convection fan noise or failure
A loud rattle or a fan that has stopped can affect baking performance. A failing fan motor and loose fan blade are common.
What to check before you request service
A few minutes of preparation can save a visit, or at least make the visit faster. Work through this list, and stay safe: unplug the appliance before touching anything behind panels.
- Check the circuit breaker for an electric range. Many ranges use a double-pole breaker, and half of it may have tripped.
- Try each burner and the broil function. Which parts work narrows down the cause.
- Use an oven thermometer to see if the actual temperature matches what you set.
- Look at the bake element for visible breaks, blisters, or burn marks, with the oven off and cool.
- On a gas range, check that the gas supply valve is open, and that burner caps are seated correctly.
- Record the brand, model, serial number, and any error codes shown on the display.
- Tell the provider whether the range is freestanding, slide-in, built-in, or a wall oven.
Typical oven & range repair costs in the Seattle area
Prices vary with brand, model, the part needed, and access to the appliance. The ranges below are general estimates to help you recognize a reasonable quote. They are not quotes from any provider, and the independent provider you speak with sets the actual price.
| Repair | Typical range | Notes |
|---|---|---|
| Diagnostic or service call | $75 – $150 | Often credited toward the repair if approved. |
| Bake or broil element | $125 – $300 | One of the most common electric oven repairs. |
| Gas oven igniter | $150 – $325 | A frequent cause of a gas oven that stays cold. |
| Temperature sensor | $125 – $275 | Affects accuracy and consistency. |
| Surface burner element or receptacle | $100 – $250 | Per burner. |
| Door latch or lock motor | $175 – $400 | Common after self-clean cycles. |
| Convection fan motor | $175 – $400 | Wall ovens often cost more. |
| Control board or display | $250 – $650 | Higher for premium models. |
For a broader comparison across appliances, read the appliance repair cost guide, and use the estimate checklist before you approve any work.
Brands people ask about
These are brands that homeowners commonly mention in repair requests. Coverage depends on the independent provider, and some premium or built-in lines need specialist service. We have no affiliation with these brands.
- GE
- Whirlpool
- Samsung
- LG
- Frigidaire
- Kenmore
- KitchenAid
- Maytag
- Bosch
- Thermador
- Wolf
- Viking
- Miele
How a request works
Tell us what is wrong
Share the brand, model and symptoms of your oven & range, your city and ZIP code, the symptoms, and your preferred timing. No payment details are needed.
We look for a fit
With your permission, we share your request with an independent provider that covers your area and appliance, when one is available.
You decide
The provider confirms availability, the diagnostic fee, and the repair price directly with you. You approve the work, or you decline.
Where we accept oven & range repair requests
Requests are accepted across the Seattle metro area. Provider coverage varies by ZIP code and appliance, so a match is not guaranteed.
Related guides
- Appliance Repair Estimate Checklist: What to Ask Before You Approve
- Appliance Repair Cost in Seattle: General Estimate Ranges
- Repair or Replace an Appliance: A Practical Decision Guide
Other appliances
Customer reviews
No reviews yet.
We do not publish ratings or testimonials we cannot verify. Real feedback from customers will appear here once requests have been completed.
Oven & range repair FAQ
Why is my oven not heating but the stovetop works?
On an electric oven, the bake element is the most common reason. On a gas oven, the igniter is often weak. The control board or a temperature sensor can also be the cause.
How much does oven repair cost in Seattle?
Typical repairs run $125 to $450 including parts and labor, and control boards on premium models can cost more. These are general estimates rather than quotes from a provider.
Can you repair gas ranges?
We do not do repairs ourselves. Some independent providers service gas appliances and some do not, so state gas or electric in your request.
My oven temperature is off. Is that a repair?
Sometimes the oven can be recalibrated. If the sensor is failing, it may need replacement. Check with an oven thermometer first.
Is it worth repairing an old range?
If the range is less than 15 years old and the repair is modest, repairing is usually sensible. For very old units or costly boards, replacement may make more sense. See our repair or replace guide.
Is it safe to use the oven if the door does not close tightly?
It is better not to. Heat can escape and the oven may overheat controls. Request service.
Do I pay you for the connection?
No payment is requested on this site. You pay the independent provider directly after you approve the estimate.
Need oven & range help?
It takes about two minutes. Share the appliance, your ZIP code and the symptoms, and we will look for an independent provider in your area.
No appointment or response time is guaranteed. Provider availability varies by ZIP code.